Interflex Datensysteme GmbH
10/13
5 Synchronizing the Reader and Setting the LED Color
Structural conditions may make it necessary to fine-tune or readjust the reader. To do so, the adjustment set
with the order number 75-99-0004 is required.
In order to achieve the best result, perform fine tuning at the location of use while the back panel is
attached.
1
Anti-tamper switch
3
Screw for adjusting the reader
2
Terminal clamps
4
2-pin DIP switch for setting the LEDs
Switch on the power supply.
Turn the adjusting screw (3) until the field indicator reaches maximum.
Setting the LEDs
Use the DIP switch (4) to set the LEDs according to the color of the display. The switch setting is usually
preset (factory default).
Check the setting of the DIP switches according to the table specifications.
Design
Switch 1/design color white
Switch 2/design color blue
Glass, white
OFF
ON
Glass, black
ON
ON
Further settings are reserved for other designs.
6 Device Settings
6.1 Setting the hardware address
Use the address switch to set the hardware address of the device.
Switch
4
3
2
1
Address 1
OFF
OFF
OFF
OFF (not required if connected to a master terminal)
Address 2
OFF
OFF
OFF
ON
Address 3
OFF
OFF
ON
OFF
Address 4
OFF
OFF
ON
ON
Address 5
OFF
ON
OFF
OFF
Address 6
OFF
ON
OFF
ON
Address 7
OFF
ON
ON
OFF
Address 8
OFF
ON
ON
ON
