Interacoustics Eclipse ABRIS, Инструкция по эксплуатации

Страница: 33 / 149

D-0120588-B
–
2019/03
Eclipse
–
Instructions for Use - EN Page 25
The waveform reproducibility calculation time frame can be adjusted (position/time frame) in the protocol
setup or by simply dragging the bold black line at each end or by grabbing it with the mouse and sliding it
back and forth along the time scale. The wave reproducibility will be recalculated immediately according to
the new time frame/position.
3.1.23 Start / Stop
The Start and Stop button are used for starting and stopping the measurement. The Start button changes
into a Stop button when a recording is started.
3.1.24 Pause
Pause becomes active after testing has started. It allows for pausing during a test. The stimulus will
continue to be presented, but no measurement is occurring.
3.1.25 Next intensity
Use the Next Intensity button to start testing the next intensity selected in the Manual Stimulus window.
3.1.26 Fmp & residual noise graph
The Fmp & Residual Noise Graph provide information about the quality of the selected curve.
1. The Quality Target (%) (e.g., 99.0%) and the horizontal grey line extending out from the black arrow
indicate the target response quality and relate to the Fmp value. The aim is for the Fmp curve to hit
the horizontal grey line.
2. The Fmp value is calculated and displayed during testing and is available for collected curves after
testing.
3. The Fmp curve (in either red or blue depending on test ear) indicates the development of response
confidence over the course of the test.
4. The black arrow and the value in nV (e.g., 40nV), indicate the Residual Noise Target.
5. The Residual Noise value is calculated and displayed during testing and is available for collected
curves after testing.
6. The Residual Noise Curve (in black) indicates the change in residual noise level over the course of
the test.
7. The number of selected sweeps for testing is indicated.