Inter-fab X-stream, Сборка и инструкция по эксплуатации

Страница: 9 / 14

- 9 - 9
Fig. 2.: Ladder Step Support Sub-Assembly
Step Two: Slide Legs
•
Install remaining foot receivers on the long and short legs, using
3/8” x 2” bolts in four locations. Push PVC pipe all the way to the bottom of
the foot receiver. Push 3/8”x 2” bolt thru 3/8” thru 3/8” flat washer, thru
pre-drilled holes provided in PVC pipe and foot receiver, through 3/8” flat
washer, and thru 3/8” nylon locking nut. Note: Do not confuse the four Foot
receiver holes in PVC pipe with the four Flume receiver holes at top. (Foot
receiver holes can be seen through 6” PVC pipe after pipe is pushed all the
way down to bottom of Foot receiver). Tighten all connections. (Fig. 3, 4)
Use Hardware Set #1
Figs. 3, 4
Short Leg and Long Leg with Foot Attached