Inter-fab X-stream, Сборка и инструкция по эксплуатации

Страница: 12 / 14

- 12 - 12
Fig. 9
Step Five: Anchoring to Deck
•
Position all foot receivers on deck in the correct location, checking to insure
the legs are vertical, then carefully mark the locations of all anchor bolts. If
proper care is exercised, drilling of leg anchor bolt holes may be done with
leg foot receivers in position; in this case, mark the location of holes for the
slanted Step Support anchor bolts before moving slide aside (holes may not
be easily drilled with this piece in position due to interference with the steps).
•
Move the slide aside, if necessary, to drill the slanted Step Support anchor
bolt holes.
•
Install Anchor Bolts at correct locations. Anchor bolt thread must protrude
1-1/2 inches above the deck. Use Hardware Set #4.
•
Install foot receivers onto deck on anchor bolts previously installed. (Fig. 10)
•
Tighten all connections.
Fig. 10
16 degree slope
from vertical
Anchor Bolts must extend
1-1/2” above deck. Holes
may be drilled in place for
vertical legs, but for
slanted column, may be
marked, and drilled after
slide is moved slightly to
the side.