I N S T A L L A T I O N M A N U A L
X - S T R E A M 2 ™ S L I D E
13
XS2-IM Rev. 10/14 (SBK-XS2 INSTALL)
STEP FOUR: Assemble the Flume Sections – CONT.
Utilizing hardware kit XS2-102-SS, attach the exit section to the lower flume section. Align
the five holes in the flange, push 3/8” bolt through a flat washer, then through the pre-drilled
holes in the flanges, then push bolt through a flat washer, then a lock washer and through
a 3/8” nut. Hand tighten at this time.
STEP FIVE: Alignment of Flume Sections
There is enough tolerance in the flange connections to provide a smooth and even transition
of the sliding surface between the flume sections.
Once the two flume sections and the exit section are bolted together hand tight, then gently
push or pull on the flume sections to ensure a smooth even alignment of the sliding surface.
Next, starting with the exit section, tighten the center bolts first and then tighten the two
outer bolts maintaining a smooth sliding surface.
Repeat this process on the flange between the upper and lower flume.
Fig. 10
STEP SIX: Attach the Legs to the Flume
Insert the top of the long leg into leg receiver of the upper flume, and the top of the short
leg into the leg receiver of the lower flume. Alight holes, then utilizing hardware kit XS-103-
SS, place a 3/8” Flat Washer over a 3/8 x 7 ½” Bolt and push the bolt through the pre-
drilled holes in the PVC leg all the way through and out the opposite side. Place a 3/8” Flat
Washer then a 3/8” Lock Washer followed by a 3/8” Hex Nut and hand tighten only. Repeat
with a second 7 ½” bolt to secure the legs to the flume sections, hand tighten only.
NOTE: Push the 7 ½” Bolts through the parts in the direction that the Bolt Heads
face away from the pool as illustrated in Figure 11.2.
Fig. 11: Flumes/Exit Assembly
Fig. 11.2
