BATTERY DISCOECT
INTELLITEC
PDX RV LLC
With an assistant, press and hold momentary
switch, at the same time check for voltage across
the coil terminals (+ on the "S" terminal and
ground on the "I" terminal),
If 0 volts go to step
59. If voltage is 10.5 VDC or larger between the
“S” & “I” terminals, replace chassis relay.
Remove battery disconnect panel from cabinet /
console and with a multi-meter set on DC voltage,
measure between the orange wire at pin # 7 and the
black wire on pin # 12
.
The voltage should read
the same approximate value as the
batteries. If not
replace harness, refer to PARTS LINK#1 (page 7).
If the voltage reading is the same go to step 60.
Trouble Shooting
Problem
Chassis Relay won't
disengage (unlatch),
BD2 & BD3
MODELS ONLY
Possible
Cause / Solution
STEP 58
STEP 59
With a multi-meter set on DC voltage, measure
between the orange wire at pin # 7 and the violet
wire on pin #6 while the switch is depressed
.
The
voltage should read the same approximate value as
the
batteries. If not replace disconnect panel, refer
to PARTS LINK # 2 (page 7). If the reading is the
same go to step 61.
STEP 60
With a multi-meter set on DC voltage, measure
between the black wire at pin # 12 and the gray
wire on pin # 8 while the switch is pressed
.
The
voltage should read the same approximate value as
the
batteries. If not replace disconnect panel, refer
to PARTS LINK # 2 (page 7).
STEP 61
Trouble Shooting
Problem
Possible
Cause / Solution
Chassis indicator light on
panel remains on, although
relay is off.
BD2 & BD3
MODELS ONLY
Is engine running / ignition switch on, turn engine
off and retest
If the panel fails retests then go to step 63.
STEP 62
18
Содержание Battery Disconnect BD0
Страница 22: ...PAGE 22...
Страница 23: ...PAGE 23...