4
Precautions before installing
Do not install the unit in the following locations; installation in these areas will cause the
unit to malfunction:
•
Locations where the unit is under direct sunlight or where direct sunlight can pass
over the unit.
•
Locations where the unit can come into direct contact with water.
•
Locations where there is high levels of humidity and condensation.
•
Locations where corrosive, reductive or neutral gases are present.
•
Locations where the temperature can fall below -10ºC or exceed 40ºC.
•
Locations that are lower than -20m or higher than 2000m above sea level.
Installation Location
•
Install the unit where is will be easy to use as shown in the figure below.
•
Please use a dedicated fused spur for each hand dryer.
•
The hand Dryer must be reliably earthed.
•
The bottom of the unit must be at least 150mm above the floor to allow for
airflow into the hand dryer.
•
The left side of the unit must be at least 150mm away from walls as the power
switch is accessed from the left side of the hand dryer.
•
Do not mount the hand dryer behind doors where the opening of the door may
damage the dryer.
•
The Mounting plate must be mounted on a completely flat surface. If the wall is
not flat, mount a flat timber or board on the wall to give a completely flat surface
to mount the hand dryer on to.
•
Do not install the hand dryer with the power connected; the dryer must be
connected by a qualified electrician when being installed
