Intellian t110W, Инструкция по установке и эксплуатации

Страница: 93 / 98

93
PC CONTROLLER SOFTWARE
Diagnosis and Set Antenna Parameters for Control
Select “Diagnosis and Set Antenna Parameters for Control” from the controller menu.
Command Buttons
•
Diagnosis: If the “Diagnosis” button is pressed, the system will carry out the
selected full diagnosis “Test All” or single diagnosis. The software will display
the diagnosis results (Blue dot represents “normal”, red represents “abnor
mal” and green represents “the diagnosis is under process”).
•
Ready: To confirm to the tilt bias setting. After pressing the Ready
button, a remote tilt calibration is required to align the level cage
assembly correctly by pressing buttons to adjust elevation and
cross-level angle so that all sensors will be aligned accurately to the axis
they related to. The fluid filled tilt sensor provides a two dimensional
horizon reference. The system is not able to be automatically calculated to
the exact center value, therefore, it is necessary to perform this
procedure to manually enter any offsets required to make sure the PCU
receives a true reference to the horizon. The fluid filled tilt sensor
provides a two dimensional horizon reference. The system is not able to
be automatically calculated to the exact center value, therefore, it is
necessary to perform this procedure to manually enter any offset
required to make sure the PCU receives a true reference to the horizon.
•
Set Bow Offset: To confirm the bow offset settings.
•
Set Parameter: To confirm the searching parameter settings.
Figure 41. Diagnosis and Set Antenna Parameters for Control