Intelix
DIGI-HD-8X8
Installation Manual
www.intelix.com
11
RS232 Remote Control
The DIGI-HD-8X8 supports remote control through a rear panel RS232 control
port.
1.
If controlling the DIGI-HD-8X8 through the RS232 control port on the rear
panel, connect a straight-through serial cable directly to the matrix.
115200 baud rate
8 data bits
1 stop bit
No handshake
Ethernet Remote Control
The DIGI-HD-8X8 supports remote control through a rear panel Ethernet
control port. The matrix accepts control messages when integrated to a local
area network (LAN).
1.
If controlling the DIGI-HD-8X8 through the Ethernet control port on the
rear panel, connect an Ethernet cable directly to the matrix.
2.
Connect the opposite end of the Ethernet cable to a LAN port. Within 10
seconds of connecting the DIGI-HD-8X8 to the LAN, the yellow LED on
the matrix’s Ethernet port will stop blinking and the green LED will blink
intermittently.
Note:
The DIGI-HD-8X8 will automatically be assigned an IP
address when connected to a DHCP-enabled network.
Connection Troubleshooting:
If the matrix does not respond with
a green LED, please follow the steps below:
-
Verify the LAN has DHCP support.
-
Verify the LAN port is active.
-
Verify the Ethernet cable has the correct wiring (568A or
B, straight-through) and the RJ45 connector is properly
terminated.
-
Verify the connecting computer is configured to use
DHCP.
-
Verify the connecting computer successfully connects to
the internet. If it does not, contact the network
administrator for assistance.
Note:
For RS232 programming and command information, see
Appendix A.
Note:
For Ethernet programming and command information, see
Appendix A.
