Intelix
DIGI-HD-4X2
Installation Manual
www.intelix.com
15
Ethernet Remote Control
The DIGI-HD-4X2 supports remote control through a rear panel Ethernet
control port. The matrix accepts control messages when integrated to a local
area network (LAN).
1.
If controlling the DIGI-HD-4X2 through the Ethernet control port on the
rear panel, connect an Ethernet cable directly to the matrix.
2.
Connect the opposite end of the Ethernet cable to a LAN port. Within 10
seconds of connecting the DIGI-HD-4X2 to the LAN, the yellow LED on
the matrix’s Ethernet port will stop blinking and the green LED will blink
intermittently.
Controlling the Matrix over a LAN
Intelix provides a diagnostic software utility,
NetCtl
, to
determine the IP address of the DIGI-HD-4X2. Please visit
Intelix’s online technical library to download the latest
version of the software:
http://www.intelix.com/tech_library/software.htm.
1.
Download and install
NetCtl
on your computer.
2.
Launch the utility. Two buttons appear.
Note:
The DIGI-HD-4X2 will automatically be assigned an IP
address when connected to a DHCP-enabled network.
Connection Troubleshooting:
If the matrix does not respond with
a green LED, please follow the steps below:
-
Verify the LAN has DHCP support.
-
Verify the LAN port is active.
-
The LAN port on the DIGI-HD-4X2 requires the use of an
Ethernet crossover cable if the hub or switch that you are
connecting to does not support
Automatic MDI/MDI-X.
-
If you continue to have issues getting the matrix to connect
to the LAN, verify LAN connectivity using a PC. If you
can not get a PC to connect, contact a network
administrator for assistance
