Intelix
DIGI-HD-4X2
Installation Manual
22 www.intelix.com
How do I switch the device to HDMI 1.2 (factory default) mode?
To switch the matrix to HDMI 1.2 (factory default) mode, please perform the
following steps:
1.
Power on the DIGI-HD-4X2 matrix.
2.
Disconnect the input sources from the DIGI-HD-4X2.
3.
Disconnect the output destinations to the DIGI-HD-4X2. Disconnect any
twisted pair extenders.
4.
Simultaneously press and hold the
Output 1 Source Select
and
Keylock
buttons for five seconds. The front panel source select LEDs will illuminate
and flash during mode transition.
5.
After the LEDs cease flashing, release the
Output 1 Source Select
and
Keylock
buttons. The DIGI-HD-4X2 is now in HDMI 1.2 (factory default)
mode.
Does the matrix support both HDMI 1.2 and HDMI 1.3 mode
simultaneously?
The DIGI-HD-4X2 does not support HDMI 1.2 and HDMI 1.3 mode
simultaneously. The matrix must be toggled for one or the other.
My destination is capable of Dolby TrueHD® but it’s not receiving
an HD signal from the Blu-ray® player.
The DIGI-HD-4X2 may not be set in HDMI 1.3 (Dolby TrueHD®) compatible
mode. Switch the matrix to HDMI 1.3 mode by following the steps on page 11.
Note:
The DIGI-HD-4X2 features on-board memory. Settings are
stored during power off and restored during power on.
Note:
Not all Blu-ray® discs are mastered with Dolby TrueHD ®
audio. Please verify your movie is encoded with this format.
