Intelbras IVP 3000 PET, Руководство пользователя

Страница: 8 / 13

8
4. For installation directly on the wall, drill the holes in the positions indicated on the back cover. For installation in the corner of the
wall, drill the holes in the positions indicated on the side of the back cover;
Montado na parede Montado no canto
da parede
Mounted on the corner
of the wall
Mounted on the wall
5. Pass the cables through the holes in the back cover and fix the sensor to the wall, make sure that the back cover is
parallel to the wall;
6. Snap the board back into the back cover and connect the cables to the terminal block, as indicated in the item 2.3.
Terminal Block;
7. Align the screw that secures the board with the arrow indicated on the board and tighten the screw. Place the front cover.
4.2. Installation without using the articulator
Note:
if the sensor is installed at an angle to the ground, the characteristics of the PET function will change.
1. Repeat steps 1 and 2 of the item 4.1. Installation without using the articulator;
2. Tear the seal on the back cover to connect the articulator;
LACRE Seal