Intel SE440BX - Desktop Board Motherboard, Руководство по эксплуатации продукта, Страница: 30 / 66

Installing and Replacing Motherboard Components
30
CAUTION
To be fully compliant with all applicable Intel
®
SDRAM memory specifications, the motherboard
should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If
your memory modules do not support SPD, you will see a notification to this effect on the screen at
power up. The BIOS will attempt to configure the memory controller for normal operation.
However, DIMMs may not function under the determined frequency. You can access the PC Serial
Presence Detect Specification at:
http://www.intel.com/design/pcisets/memory/
✏
NOTE
All memory components and DIMMs used with the SE440BX-2 motherboard must comply with the
PC SDRAM specifications. These include: the PC SDRAM Specification (memory component
specific), the PC100 SDRAM Component Testing Summary, the PC Unbuffered DIMM
Specification, and the PC Registered DIMM Specification. You can access these documents
through the Internet at:
http://www.intel.com/design/pcisets/memory/
Figure 12 shows the location of the DIMM sockets.
OM07171
1
2
0
Figure 12. Location of DIMM Sockets
To install DIMMs, follow these steps:
1. Observe the precautions in “Before You Begin” (see page 19).
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the computer cover and locate the DIMM sockets.
4. Holding the DIMM by the edges, remove it from its antistatic package.
5. Make sure the clips at either end of the socket are pushed away from the socket.