Intel SBXD62 - Server Compute Blade, Инструкция по установке и эксплуатации

Страница: 57 / 118

Intel® Server Compute Blade SBXD62 Installation and User’s Guide 47
Microprocessor problems
Monitor Problems
Note: The monitor screen remains blank until it is directed to a blade server that is turned on;
this is normal behavior.
Symptom Suggested action
The blade server emits a
continuous tone during
POST. The startup (boot) microprocessor is not working correctly.
Make sure that the startup microprocessor is seated correctly. If it is, replace the
startup microprocessor.
If the problem remains, call for service.
Symptom Suggested action
The monitor screen goes
blank when you direct it to
a working blade server, or
it goes blank when you
start some application
programs in the blade
servers. Make sure that the monitor cable is connected to the video connector on the
management module.
Some monitors have their own self-tests. If you suspect a problem with your
monitor, see the information that comes with the monitor for adjusting and
testing instructions.
If you still cannot find the problem, try using the monitor with another blade
server. If the problem remains, see the
Intel® Blade Server Chassis SBCE
Hardware Maintenance Manual and Troubleshooting Guide on the Resource CD
that came with your Intel® Blade Server Chassis SBCE.
The screen is blank. Make sure that:
•
The KVM select button LED on the front of the blade server is lit, indicating
that the blade server is connected to the shared monitor.
•
The Intel® Blade Server Chassis SBCE power cord is connected to the
power module and a working electrical outlet.
•
The monitor cables are connected properly.
•
The monitor is turned on and the brightness and contrast controls are
adjusted correctly.
Important: In some memory configurations, the 3-3-3 beep code might sound
during POST followed by a blank monitor screen. If this occurs and the Boot
Fail Count feature in the Start Options of the Configuration/Setup Utility
program is enabled (its default setting), you must restart the blade server three
times to force the system BIOS to reset the configuration settings to the default
configuration (the memory connector or bank of connectors enabled).
If the problem remains, call for service.
Only the cursor appears. Make sure that the keyboard, video, and mouse on the Intel® Blade Server
Chassis SBCE have not been switched to another blade server.
If the problem remains, call for service.