21
Complete the following steps to open the blade server cover:
1. Read the safety information beginning on page “Safety” on page vii and “Installation
guidelines” on page 19.
2. Carefully lay the blade server down on a flat, non-conductive surface, with the cover side up.
3. Press the blade-cover release on each side of the blade server and lift the cover open, as shown in
the illustration.
4. Lay the cover flat, or lift it from the blade server and store for future use.
Statement 21:
xx
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always
replace the blade cover before installing the blade server.
Removing the blade server bezel assembly
To install certain options, you must first remove the blade server bezel assembly. The following
illustration shows how to remove the bezel assembly from the blade server.
Complete the following steps to remove the blade server bezel assembly:
1. Read the safety information beginning on page “Safety” on page vii and “Installation
guidelines” on page 19.
2. Open the blade server cover (see “Opening the blade server cover” on page 20 for instructions).
3. Press the bezel-assembly release and pull the bezel assembly away from the blade server
approximately 1.2 cm (0.5 inch).
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Control panel
connector
Bezel-assembly
release
Bezel-assembly
release
Control-panel
cable
