Intel R2000SC, Быстрая установка руководство пользователя

Страница: 7 / 20

3
General Installation Process
6
Install Processor Heatsink(s)
A
B
C
D
If a protective film covers the thermal interface material
(TIM) on the underside of the heatsink, remove the
protective film.
Align the heat sink fins to the front and back of the
chassis for correct airflow. Airflow goes from
front-to-back of chassis.
Using a #2 Phillips* screwdriver, finger-tighten
each fastener diagonally, according to the
white-circled numbers.
Securely re-tighten each fastener again in
the same order as performed in Step C.
Server
Board
CPU 2 Heat Sink
CPU 1 Heat Sink
A
I
R
F
L
O
W
A
I
R
F
L
O
W
Processor
Soc
ket
Chassis Front
2
3
1
4
CAUTION:
Do not
over-tighten
fasteners.
NOTE: Heatsink
styles may vary
TIM
A
B
B
C D
Install the Processor(s)
B. Open the Load Plate
Open the load plate as shown.
A
B
A
B
Push the rear tab with your finger tip to bring
the front end of the load plate up slightly.
C. Remove the
Processor
Protective Cover
A
A Take the processor
out of the box and
remove the protective
shipping cover.
A. Open the Socket Lever
1. When opening a socket,
DO NOT TOUCH the gold
socket wires.
2. When unpacking a processor,
hold by the edges only to
avoid touching the gold
contact wires.
CAUTION:
A
B
Rotate the lever open all the way.
A
B
Push the lever handle down and away
from the socket to release it.
Install the Processor(s) ... continued
A
Orientation Posts
Orientation Notches
A
E. Close Load Plate and Socket Lever
A
Close the socket lever.
C
B
A B
C
Close the load plate all the way as shown.
Remove the protective cover after it been automatically disengaged
from the load plate.
Orient the processor with the socket so that the
orientation notches on the processor align with
the two orientation posts on the socket.
D. Install the Processor
CAUTION: The underside
of the processor has
components that may damage
the socket wires if installed
improperly.
DO NOT DROP processor
into the socket!
Components
Processor must align correctly
with the socket opening before
installation.
Install the
processor as
shown.
5