Hardware Installations and Upgrades
Figure 56. Installing Hard Disk Drive – Inserting 2.5
"
HDD assembly
Installing and Removing a Slimline Optical Drive
Cautions:
The slimline optical drive is NOT hot-swappable. Before removing or replacing the drive, you
must first take the server out of service, turn off all peripheral devices connected to the system, turn off
the system by pressing the power button, and unplug the AC power cord from the system or wall outlet.
To maintain proper system cooling, a filler panel must be installed if you do not install a device at this
location.
Before installing or removing the slimline optical drive, please make sure following steps are performed.
1.
Ensure the AC power cord(s) are disconnected from the system.
2.
Remove the system cover. For instructions, see
Installing a Slimline Optical Drive
1.
Install the plastic guide onto the back of the drive and attach with two screws as shown (see
letter
A
).
Figure 57. Installing the Plastic Guide to the Optical Drive
2.
Insert the optical drive into chassis opening and push all the way until it stops (see letter
B
).
Connect the cables as shown (see letter
C
).
Intel
®
Server System R2000LH2/LT2 Service Guide
35
