Error and Information Messages
PCI Configuration Error
Messages
The following PCI messages are displayed as a
group with bus, device and
Table 7.
PCI Configuration Error Messages
Message
Bad
Serial ID
Checksum
Floppy Disk
Controller Resource
NVRAM Checksum
Error, NVRAM
Cleared
Cleared By
Jumper
NVRAM Data
Invalid, NVRAM
Cleared
Parallel Port
Resource Conflict
Explanation
The Serial ID checksum of a Plug
and Play card was invalid.
The floppy disk controller has
requested a resource that is already
rn use.
The ESCD data was reinitialized
because of an NVRAM checksum
error. Try rerunning the ICU.
The “CMOS Clear” jumper has been
moved to the “Clear” position and
CMOS RAM has been cleared.
Invalid entry in the ESCD.
The parallel port has requested a
resource that is already in use.
Table 7.
PCI Configuration Error Messages
(continued)
Message
PCI Error Log is Full
PCI I/O Port Conflict
PCI
Conflict
PCI Memory
Conflict
Primarv Boot
Device Not Found
Primary IDE
Controller Resource
Conflict
Primary Input
Device Not Found
Explanation
than
errorsare
detected. No additional PCI errors
can be logged.
resource, resulting in a conflict.
Two devices requested the same
resource, resulting in a conflict.
Two devices requested the same
resource, resulting in a conflict.
(hard disk drive, diskette drive,
CD-ROM drive, or network) could
not be found.
The primary IDE controller has’
requested a resource that is already
in use.
The designated primary input device
(keyboard, mouse, or other, if input
is redirected) could not be found.
continued
continued