Intel MB440LX, Руководство по установке системы

Страница: 183 / 232

M440LX Server System Product Guide
183
Beep Code Message
2 Successful completion, no errors.
4 The system could not boot from the diskette. The
diskette may not be bootable.
Continuous series
of low beeps The wrong BIOS recovery files are being used
and/or the flash memory jumper is in the wrong
position.
6. Turn the system off, disconnect the power cord(s) from the system, and
remove the left side cover.
7. Move the jumper from the REC pins to the NOR pins to enable the
normal boot mode.
8. Replace the left side cover, remove the diskette from drive A, and
connect the power cord(s) to the system.
9. After running the special recovery mode, run the SCU to specify a new
password. For information on running the SCU, see Chapter 3,
“Configuring The System.”
Password
The jumper on the J2J1, Password PROT pins protects the system password
during system reset. Moving the jumper to the CLR pins clears the system
password during system reset.
To clear and enter your password, do this:
1. Observe the precautions on page 3, “Safety Guidelines.”
2. Remove the left side cover as described in Chapter 4, “Working Inside
Your System.”
3. Move the jumper on the J2J1, Password PROT pins to the CLR pins.
4. Replace the left side cover, and connect the power cord(s) to the system.
5. Turn the system on, and wait for POST to complete. This automatically
clears the password. For instructions on running POST, see Chapter 3,
“Configuring The System.”
6. Turn the system off; disconnect the power cord(s), and remove the left
side cover.
7. Move the jumper on the J2J1, Password CLR pins to the PROT pins.
8. Replace the left side cover, and connect the power cord(s) to the system.
9. Run the SCU to specify a new password. For information on running
the SCU, see Chapter 3, “Configuring The System.”