Intel ISP4400 - Server Platform - 0 MB RAM, Руководство по эксплуатации продукта

Страница: 55 / 114

Removing and Installing System Components 55
20. Remove the four screws on the top and bottom edges of the rear subchassis. These screws
attach the E-Bay to the chassis. Two of the four screws are noted as "A" in Figure 25.
OM09951
A
Figure 25. Screws Securing the E-Bay to the Chassis
21. Pull the E-Bay away from the chassis. As you separate the E-Bay away, make sure that the
power cord does not become wedged between the two parts of the chassis.
22. Remove the rug from the E-Bay.
23. Using needlenose pliers, remove the plastic rear retention mechanism located at the front of
the E-Bay.
24. Slide the baseboard towards the front of the chassis.
25. Lift the baseboard up and out on the side closest to the baseboard and VRM connectors.
Installing the Baseboard
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the four screws on the top and bottom edges of the rear subchassis. These screws
attach the E-Bay to the chassis. See Figure 25 on page 55.
3. Pull the E-Bay away from the chassis. As you separate the E-Bay away, make sure that the
power cord does not become wedged between the two parts of the chassis.
4. Hold the baseboard on the side closest to the VRM connectors and processors. Slip the
baseboard under the padding on the right side of the E-Bay and then under the back panel at
the rear of the chassis.