Intel ISP4400 - Server Platform - 0 MB RAM, Руководство по эксплуатации продукта

Страница: 50 / 114

50 SRKA4/ISP4400 Server System Product Guide
ESD and handling boards: Always handle boards carefully. They can be
extremely sensitive to ESD. Hold boards only by their edges. After
removing a board from its protective wrapper or from the system, place it
component-side UP on a grounded, static-free surface. If you place the
baseboard on a conductive surface, the battery leads may short out. If they
do, this will result in a loss of CMOS data and will drain the battery. Use a
conductive foam pad if available but NOT the board wrapper. Do not slide
board over any surface.
Cooling and air flow: For proper cooling and airflow, always install the
front cover before turning on the system. Operating the system without the
top and front covers in place for an extended period of time can damage
system parts.
Removal of the top cover for an extended period of time: If the SRKA4
MP Server System is turned on and has only three fans installed, make sure
that you install the top cover within five minutes of removing it.
Front Cover
Removing the Front Cover and Front Bezel
To reach components inside the system, remove the front cover, and in some cases the front bezel.
Facing the front of the system, the front cover is on top and towards the front of the rack-mounted
chassis. The following tasks require removal of the front cover:
•
Removing and installing non-hot-swap drives in the configurable media bay
•
Removing and installing media devices in the device bay
•
Removing and installing the fan board assembly
•
Removing and installing the power subsystem bay
•
Removing and installing a power supply module (front bezel only)
To remove the front cover, perform the following steps.
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the front bezel by gently pulling it towards you. The ball studs will release from the
chassis.
3. Remove the three screws located on the top of the chassis. These screws are noted by "A" in
Figure 14 on page 35. Save these screws; you need them later to reattach the cover.
4. Using an even pull and pressing down, slide the cover back towards the front of the chassis
about .75 inches.
5. Lift the front cover up and out of the chassis.