Intel ISP4400 - Server Platform - 0 MB RAM, Руководство по эксплуатации продукта

Страница: 28 / 114

28 SRKA4/ISP4400 Server System Product Guide
5. Grasp the locking handle and pull it toward you to disengage the drive connector from the
backplane connector. The locking handle is noted by "A" in Figure 10.
OM09942
A
Figure 10. Disengaging Drive Carrier from Chassis
6. Carefully slide the drive out of the bay. Place the drive on an antistatic surface.
Installing a SCSI Hard Drive
A bank of five LEDs on the front of the hard drive bays monitors the drive status of each drive in
the hot-docking bay. Each LED corresponds directly to a drive, so that the upper-most LED shows
activity in the upper-most drive. The LEDs and corresponding drives are numbered (left to right)
zero to four. When a yellow LED for a hard drive is on continuously, you are permitted to
hot-swap (replace) a bad drive with a good one. If the operating system installed supports
hot-swapping hard drives, the system DOES NOT need to be powered off.
1. Open the front bezel door by simultaneously pulling out on the raised lip of the front bezel
door latch. See Figure 9 on page 27.
2. Position the new carrier and drive assembly so that it engages the bay guide rails.
3. Gently push the drive into the bay. Swing the locking handle towards the chassis. The locking
handle engages the latch.
4. Close the front bezel door by pressing the door gently into the chassis.