Hardware Installations and Upgrades
Intel
®
Server System H2000JF Family Service Guide
25
Figure 35. Installing Processor – Close the Load Plate
6.
Latch the Locking Lever. Push down on the locking lever on the CLOSE 1st side (see letter
A
).
Slide the tip of the lever under the notch in the load plate (see letter
B
). Make sure the load
plate tab engages under the socket lever when fully closed. Repeat the steps to latch the locking
lever on the other side (see letter
C
). Latch the levers in the order as shown.
Figure 36. Installing Processor – Latch the Locking Lever
Installing Processor Heatsink(s)
Note:
The processor heatsink for CPU1 and CPU2 is different.
FXXCA91X91HS
(IPN:
E89205
) is
for CPU1, while
FXXEA91X91HS
(IPN:
G19642
) is for CPU2. Mislocating the heatsink will
cause serious thermal damage!
1.
Remove the protective film on the TIM if present (see letter
A
).
2.
Align heatsink fins to the front and back of the chassis for correct airflow. Airflow goes from
front-to-back of chassis (see letter
B
).
Each heatsink has four captive fasteners and should be tightened in a diagonal manner using the
following procedure:
3.
Using a #2 Phillips* screwdriver, start with screw 1 and engage screw threads by giving it two
rotations and stop (see letter
C
). (Do not fully tighten.)
4.
Proceed to screw 2 and engage screw threads by giving it two rotations and stop (see letter
D
).
Similarly, engage screws 3 and 4.
5.
Repeat steps C and D by giving each screw two rotations each time until each screw is lightly
tightened up to a maximum of 8 inch-lbs torque (see letter
E
).
