Intel EJM-HRMP131, Руководство пользователя

Страница: 32 / 65

INSTALLATION INSTRUCTIONS | 25
Installing the Tablet Into an Existing AnyPoint
Phoneline Network
Use the following steps if this is your first tablet and you already
have an AnyPoint Phoneline Home Network installed.
Begin Charging the Tablet
1 Remove the plastic pull-tab from the battery case on the
rear of the tablet.
2 Plug the AC adapter into the wall. Open the tablet access
panel and plug the AC adapter into the tablet AC power
jack.
3 Leave the tablet connected to AC power so it can begin
charging while you complete the tablet setup. The entire
installation process takes approximately 45 minutes.
Note:
If you use the flip stand on the back of the tablet to keep
the tablet upright, make sure the stand is fully extended.
Update the AnyPoint Phoneline Adapter Settings
Before installing the AnyPoint wireless USB adapter, you need
to change the AnyPoint Phoneline adapter settings.
Important!
You must update the adapter settings on each
computer that is part of the AnyPoint phoneline network.
1 At each computer that is part of your home network, open
the Windows*
Control Panel
and double-click the
Network
icon. The Network dialog displays.
2 Click the
Configuration
tab and locate the
TCP/IP -> Intel(R)
AnyPoint USB Phoneline Adapter
in the list of installed
components.
3 Click the AnyPoint adapter to select it, and then click
Properties
. The TCP/IP Properties dialog displays.
4 Click the
IP Address
tab.
5 Select the
Specify an IP address
radio button, and then
enter the following values:
IP Address: 192.168.168.1
Subnet Mask: 255.255.255.0
Note:
Each computer on your home network must have a
unique IP address. Use a unique number between 2 and
254 for the last number of the IP address on each of your
computers.
6 Click
OK
twice to close the Network dialog.
7 If you are prompted to restart the computer, click
Yes
.
Install the Tablet Software On Your Home Network Server PC
Important:
Because the tablet will connect to the Internet
through the PC, you must install the tablet software on your
AnyPoint Home Network’s server PC.
1 Shut down the PC.
2 Plug the AnyPoint adapter cable into an open USB port.
3 Turn on the PC.
4 After the PC starts up,
insert the Intel Web Tablet Setup CD
into the CD-ROM drive
. The CD is located inside the back
cover of this Product Guide.