Intel 815 Micro-ATX Mainboard
INTRODUCTION
2-4
In order to use the ring-in signal to wake up your PC system, you will have to use the
EXTERNAL MODEM
and have it connected to one of the
SERIAL PORTS
(
COM1 or COM2 ) on the mainboard. When the mainboard detects the ring-in signal
from the serial port, the system power will be turned on and start to receive the
incoming messages automatically. ( you need to have the software like Award Zero-
Volt Data-Suspend Utility so that you can use the fax utility to receive the incoming
fax message ). To enable the Modem Ring-In feature, you have to run the BIOS
setup utility and enable the “Power On by Ring / LAN” option (please refer to
Section 4.8 for the settings).
Note: This function is not available when using the internal MODEM card.
¨
WAKE ON LAN ( WOL )
There is a WOL connector CN16 on the mainboard which is designed to connect to
the signal from a LAN card which supports the Wake On LAN feature. When such
LAN card is installed, you may turn on the PC system from the remote server and
monitor the PC status. To enable this feature, you will have to use the BIOS setup
utility to enable the “Resume by Ring or LAN” in the BIOS setup program.
Note: This function will be disabled if you turn off the power before the system can
verify the DMI pool data.