Intab Tinytag Connect, Руководство пользователя

Страница: 10 / 72

8
1.4 ETHERNET RECEIVER/LAN LOGGER HARDWARE SETUP
1.4 Ethernet Receiver/LAN Logger Hardware Setup
Ethernet receivers and LAN loggers are Power over Ethernet (PoE) devices. If a PoE plug-in injector is
supplied, the device should be connected up using Ethernet cables (not supplied) as shown below:
Once connected, turn the device on.
Locate and make a note of the MAC address on the back of the device being installed, this will be
needed later.
If the device is being used in a location where moisture or dust is present, the supplied waterproof RJ45
shroud should be fitted over the Ethernet connection.
To fit this, thread the Ethernet cable through the shroud, plug the cable into the device and then screw
the shroud into the device.