23
This device meets the requirements of the following standards: EN55032,
EN55103-2, EN61000-3-2, EN61000-3-3, EN62311.
Manual Author: Collin Russell
Manual Design: Dominic D’Sylva
•
Connect the
Band Pass Output
to the input 2 of vincâ and set the
amplitude/CV attenuator of vincâ to a desired position.
•
Monitor the output of
vincâ
.
•
Set the fundamental frequency of Tš-L to a desired position.
•
Set the
Coarse
knob of
I-ō47
to around 9:00
•
Fine tune
I-ō47
with the
Fine
knob.
•
Use the
Gain
fader and the
Q
knob of
I-ō47
to interpolate between
the fold and PWM waveforms of Tš-L.
•
Set
Q
to desired position
Control Path:
•
Connect the 1V/Oct output of a sequencer to the
1V/Oct
input
of
I-ō47
.
•
Connect the gate output of the sequencer to the gate/trig input
of cèis.
•
Connect the CV output of cèis to the CV input of
vincâ
and set the
corresponding CV attenuator to a desired position.
•
Connect a sawtooth waveform LFO to the
FM Input
of
I-ō47
and
set the
FM Attenuator
to around 9:00.
•
Connect the attack gate output of cèis to the reset input of the LFO.
•
Tune the second VCO of Cš-L to unison or a intervallic 3rd or 5th
above the fundamental frequency of Tš-L.
•
Set the square waveform of the second VCO of Cš-L to sub mode
(sub button lit amber) and connect the square output to the
Strike
Input
of
I-ō47
.
•
Use
FM Attenuverter,
LFO parameters,
Gain
fader and
Q
knob to
morph and change the voice to desired effect.
