Page 5 of 14 Rev: 1/8/2013 7:36 PM
Beep on Button Press
Default = disabled
This setting is only adjustable via software or a central controller. On/Off Module will beep every time its
paddle is tapped.
INSTEON Setup
Some products have subtle differences in their setup procedures. Please refer to the other devices’
owner’s manuals for details.
INSTEON Controllers, Responders and Links
Let’s define a few terms.
•
The INSTEON “transmitter” is called a
controller
•
The INSTEON “receiver” is called a
responder
•
The association between the controller and responder is called a
link
Note that a link is one way. If you wish to have control “the other way,” simply add a link “the other way.”
Configure INSTEON Settings
Most On/Off Module links and settings can be configured locally—during installation with the module’s set
button or after installation using the switch connected to the module—or remotely via software (sold
separately).
All On/Off Module settings can be managed remotely via software (sold separately).
Make On/Off Module a Responder
1) Press and hold controller set button until it beeps
Controller LED will start blinking green
You will have four minutes to complete the next steps before linking mode times out
2) Turn on load connected to On/Off Module and adjust to desired level (on or off)
3) Press and hold On/Off Module set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off or pressing and holding to brighten/dim
Load connected to On/Off Module will respond appropriately
Note:
- The link just created is one way. See
Make On/Off Module a Controller
to add another
link to keep the two products in sync.
- If you wish the load to be off when link is activated—such as for an “all off” scene—turn off the
load in step #2.
Controller
Responder
Link
