Page 3 of 14 Rev: 1/8/2013 7:36 PM
Features and Benefits
- Integrated on/off relay
- Compatible with all INSTEON (and X10) controllers; can also act as an INSTEON (and X10)
controller
- Super-easy setup with multi-color LED and beeper
- Dual-band communicates simultaneously over both RF and powerline
- Stores setup state in non-volatile memory so settings aren’t lost during power outages
- Two-year warranty
Installation
CAUTIONS AND WARNINGS
Read and understand these instructions before installing and retain them for future reference.
This product is not designed or approved for use on powerlines other than 100-240VAC,50Hz or 60Hz, single phase. Attempting to
use this product on non-approved powerlines may have hazardous consequences.
-
Use only indoors or in outdoor rated box
-
This product may feel warm during operation. The amount of heat generated is within approved limits and poses no hazards.
To minimize heat buildup, ensure the area surrounding this product is as clear of clutter as possible.
-
Each INSTEON product is assigned a unique INSTEON I.D., which is printed on the product’s label.
-
To reduce the risk of overheating and possible damage to other equipment, do not use this product to control loads in excess
of the specified maximum(s) or, install in locations with electricity specifications which are outside of the product’s
specifications. If this device supports dimming, please note that dimming an inductive load, such as a fan or transformer,
could cause damage to the dimmer, the load bearing device, or both. If the manufacturer of the load device does not
recommend dimming, use a non-dimming INSTEON on/off switch. USER ASSUMES ALL RISKS ASSOCIATED WITH
DIMMING AN INDUCTIVE LOAD.
IMPORTANT!
If you have any difficulties or questions, consult an electrician. If you are not knowledgeable about, and comfortable with, electrical
circuitry, you should have a qualified electrician install the product for you.
In the Box
Tools Needed
Optional Accessories
On/Off Module
None
INSTEON Hub
Quick Start Guide
Mini Remote
1) Turn on lamp or appliance
2) Unplug lamp/appliance and plug it into On/Off Module receptacle
3) Plug On/Off Module into unswitched wall outlet
Load will turn on
On/Off Module LED will turn green
