INSTEON KeypadLinc Dimmer User’s Guide
Page 5 of 39
Note
Proper installation of at least two Access Point modules is highly recommended for an
INSTEON network. INSTEON has only officially been tested in a 2-phase residential
environment, but has been known to work in many 3-phase systems, where 3 Access Points
are used (one on each phase). However, due to the potential complexity of its troubleshooting,
Smarthome Technical Support is unable to support INSTEON in 3-phase environments.
HOW TO INSTALL KEYPADLINC DIMMER
Typical Tools You Will Need
•
A flat screwdriver to remove the faceplate from the switch junction box.
•
A Phillips screwdriver for the screws that hold KeypadLinc Dimmer in the junction box.
•
A wire cutter and stripper if the switch you are replacing requires you to cut the wires to remove them.
•
A small Phillips screwdriver if you will be changing the color of the trim frame and paddle.
Caution
Read and understand these instructions before installing, and retain them for future reference.
KeypadLinc Dimmer is intended for installation in accordance with the National Electric Code and local regulations in the
United States, or the Canadian Electrical Code and local regulations in Canada. Use indoors only. KeypadLinc Dimmer
is not designed nor approved for use on power lines other than 120V 60Hz, single phase. Attempting to use KeypadLinc
Dimmer on non-approved powerlines may have hazardous consequences.
Do not install KeypadLinc Dimmer to control a receptacle or fluorescent lighting fixture. Connect only copper or copper-
clad wire to KeypadLinc Dimmer. Before installing, disconnect power at the circuit breaker or remove the circuit’s fuse
to avoid shock or possible damage to KeypadLinc Dimmer. It is recommended that a qualified electrician perform this
installation.
To reduce the risk of overheating and possible damage to other equipment, use KeypadLinc Dimmer to control 110V
incandescent lamps only. Dimming an inductive load, such as a fan or transformer, could cause damage to the dimmer,
the load device, or both. If the manufacturer of the load device does not recommend dimming, use a non-dimming
INSTEON switch such as SwitchLinc Relay. USER ASSUMES ALL RISKS ASSOCIATED WITH DIMMING AN
INDUCTIVE LOAD.
A Helpful Tool – Voltmeter or Voltage Tester
During the installation of KeypadLinc Dimmer, it may be necessary to identify the wires inside the junction box. Knowing
for sure which wire is the LINE (sometimes called HOT) can reduce the guesswork when installing a single switch, and it
is absolutely necessary when working with multi-way lighting circuits. A voltmeter is ideal for this application. Many of
the digital models can also read current so you can measure how much power is being drawn by the switch’s load.
A simpler measurement tool, available at most home improvement centers, is a voltage sensor. This device, often
costing less than $20, can sense voltage when placed near a wire. The tip of the voltage sensor can tell if voltage is on
the wire without touching the bare copper conductor or breaking the insulation.
When using these tools, be certain to read and understand the safety instructions. Often when these tools are used, the
power to the circuit will need to be turned on. When working around live electrical wires, take your time and concentrate
on the task.
