Inspur AS500H, Руководство пользователя

Страница: 15 / 56

second hole above the starting point of 32U scale on angle rail, the upper connector with the
second hole above the starting point of 33U scale, insert the connector through the hole, and
then press it down, to connect it to angle rail, now L-shaped part of guide rail shall be leveled
with the starting point of 32U scale, and rear rail fixing holes shall display in the center of the
third hole above the starting point of 32U, as shown in Figure 4-2.
Figure 4-2
5. Adopt guide rail standard configuration of M5×6 round head screws, screw in rear
rail fixing holes, to fix guide rail.
6. Adjust fixing positions of two fixing columns of front guide rail as required, so as to
leave corresponding positions for front fixing holes of the equipment, place guide rail to a
horizontal position, align lower edge with 32U starting point, extend fixing columns into
angle rail fixing holes, and fix them with round head M5×6 screws, as shown in Figure 4-3,
while fixing positions of round head M5×6 screws are also required to be ascertained
according to corresponding positions of front fixing holes of the equipment, so as to avoid.
Rear rail fixing hole
Keep level