Insportline IN 2207, Руководство пользователя

Страница: 68 / 73

cannot higher than the edge bushing.
3. Install the Handlebar Post and Tension
Control
Knob.
Remove four M8x15 Bolts (24) and Ø8 Curve
Washers (37) from the tube of the Main Frame (1).
Insert the Tension Cable (60) through into the
bottom
hole of Handlebar Post (3) and pull it out from the
square hole of Handlebar Post (3). Connect the
Sensor Wire (26) from the Main Frame (1) to the
Middle Section Sensor Wire (59) from the
Handlebar
Post (3).
Insert the Handlebar Post (3) onto the tube of the
Main Frame (1) and secure with four M8x15 Bolts
(24) and Ø8 Curve Washers (37) that were removed.
Remove the M5x25 Bolt (57) and Ø5 Big Curve Washer (62) from the Tension Control Knob
(7). Put the cable end of resistance cable of Tension Control Knob (7) into the spring hook
of Tension Cable (60) as shown in drawing A of figure 3. Pull the resistance cable of
Tension Control Knob (7) up and force it into the gap of metal bracket of Tension Cable (60)
as shown in drawing B of figure 3. Attach the Tension Control Knob (7) onto the Handlebar
Post (3) with the M5x25 Bolt (57) and Ø5 Big Curve Washer (62) that were removed.
3