Inspire VLF-3, Руководство по сборке

Страница: 21 / 25

VLF-3 Rev #1C Assembly Instructions
21
Solder the black “RTN” wire to the RTN side of the antenna
terminal.
Insert the red wire into the BNC connector and solder in place.
Solder both red wires to the “ANT+” side of the antenna terminal.
Use the set screws to attach the knobs to the 10k pot shafts.
Install a 9-volt battery in the battery holder.
Use the 4 6/32 1/4 inch screws to attach the faceplate
to the enclosure.
Close-up showing wires soldered to the jack tabs
NOTE: The orange and yellow wires must cross to connect to the appropriate
jacks.