Inspire VLF-3, Руководство по сборке

Страница: 15 / 25

VLF-3 Rev #1C Assembly Instructions
15

1d. Install the inductors (L1 and L2)
The inductors are the two remaining parts in Bag #1. Inductor L1 is marked “LH 239”.
Inductor L2 is marked “LJ 415”. From the component side, press the inductor firmly
down against the PCB and solder the other side. There is no required polarity for the
inductors.

1e. Install the diodes from Bag #3
Polarity is very important in the installation
of diodes.
D1 and D2 are black cylinders with a silver
stripe near one end.
On the PCB, the D1 and D2 locations are
shown as a rectangle with a stripe near one
end.
Align the striped end of the diode with the striped end of the PCB symbol. Press the
diode firmly against the component side of the PCB and solder the other side.
Z1 and Z2 are small components with a black stripe near one end. The symbol on the
PCB is the same as for D1 and D2. As with D1 and D2, align the black stripe end with
the striped end on the PCB. Press the diodes firmly against the PCB and solder the
other side.
Return the LEDs to Bag #3. They will be installed later.
D1
1N
4004
Remaining Bag #3
D1, D2 Z1, Z2 LED1, LED2