Inspire VLF-3, Руководство по сборке

Страница: 16 / 25

VLF-3 Rev #1C Assembly Instructions
16

1f. Install the battery holder
From Bag #4, take the following parts:
1 Battery holder
2 PCB standoff post
2 4-40 3/8 “ screw
4 4-40 1/4” screw
2 4-40 nuts
2 nylon washers
2 #4 washers
The following diagram shows the assembly of the battery holder to the PCB:
.
1. Place the battery holder
leads through the PCB
from the component side
and press the holder firmly
against the PCB.
2. Insert 1/4” screws through
the holes nearest the
leads, through the PCB
and tighten the nuts on
the switch (solder) side.
3. Insert 3/8” screws through
the other two holes,
through the PCB, through
the nylon washers and
tighten the standoffs on
the switch (solder) side.
4. Solder the battery leads
on either (or both) side of
the PCB.
5. Temporarily insert 1/4”
screws through the #4
washers in the other ends
of the standoffs. These
will be used later to attach
to the faceplate.