Insinger ADMIRAL 44 ADVANCED, Техническое руководство

Страница: 17 / 39

Document: 9700 - 03499 Rev B 17 www.insingermachine.com 800 - 344 -
Insinger dishmachines are user - friendly, making
them the easiest dishmachines on the market to
operate and maintain.
By following these operating procedures your In-
singer dishwasher will give you years of trouble
free service.
OPERATION INSTRUCTIONS
1. Ensure drain stopper is in place. Close all tank
drain valves. One drain is provided for each
tank of the dish machine.
2. Check for proper installation and cleanliness of
all internal, removable components such as
suction strainers, scrap screens, and spray
manifolds.
3. Ensure all water, steam, and gas lines are
open. Ensure electrical circuits are on.
4. Close machine doors.
PART 3 OPERATION INSTRUCTIONS
5. Press Power Button.
6. The machine will begin to fill.
7. When the tanks are full the tank heat will oper-
ate automatically.
CAUTION:
To ensure proper operation
of the auto tank fill feature and the tank heaters,
the tank level floats MUST be cleaned daily.
CAUTION:
Overloading racks will impede proper cleaning of the
ware and also put extra strain on the conveyor system.
8. Once machine reaches minimum wash tank
temperature.
9. The system is now ready for operation. All ware
should be properly scrapped. Do not overload
racks.
10. Slide the rack into the dish machine, the convey-
or
11. Rack will pass through the various machine cy-
cles then machine will turn off. (as long as racks
are present inside machine, machine will remain
operational)
12. Should a conveyor jam occur, the CONVEYOR
JAM will be displayed, LED bar will blink red, and
the machine will shutdown. To re - start the ma-
chine, clear the conveyor jam. If jam is sever
press power button then remove jam. Door will
need to be opened and closed as indicated in
display.
13. Press POWER switch to turn OFF machine.
14. Refer to the cleaning procedures for proper
cleaning of the dish machine.
15. Report any unusual occurrences to qualified ser-
vice personnel.

NOTE:
An interlock is provided to shut the machine
down if the doors are open, therefore the
machine will not run if the doors are opened.
Initial Start - Up Adjustments
Final Rinse Pressure Adjustment
1. The final rinse pressure must be adjusted to
20PSI. This is done by adjusting the pressure
regulator.
Temperature Adjustment
1. Open control box cover. Open front door then
press and hold button 4 on membrane switch
located inside control box for 3 seconds.
2. Use button 3 to scroll to desired temperature
(Wash or Rinse).
3. Change value using button 1 or 2.
4. Select button 4 to save change / exit.
 NOTE:
Temperatures are preset at factory for opti-
mal operation.