15
Insignia 42" LED-LCD HDTV, 1080p
www.insigniaproducts.com
Connecting an antenna or cable TV (no box)
To connect an antenna or cable TV (no box):
1
Make sure that your TV’s power cord is
unplugged, and all connected equipment is
turned off.
2
Connect a coaxial cable to the
ANT/CABLE
jack
on the back of your TV and to the antenna or
cable TV wall jack.
3
Plug your TV’s power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
4
Go through the setup wizard on page 22.
Connecting a DVD or Blu-ray player
Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1
Make sure that your TV’s power cord is
unplugged and the DVD or Blu-ray player is
turned off.
2
Connect an HDMI cable (not included) to an
HDMI
jack on the back or side of your TV and to
the
HDMI OUT
jack on the DVD or Blu-ray
player.
3
Plug your TV’s power cord into a power outlet,
turn on your TV, then turn on the DVD or Blu-ray
player.
4
Press
INPUT
to open the
Input Source
list.
5
Press
S
or
T
to highlight
HDMI 1
,
HDMI 2
,
HDMI 3
, then press
ENTER
.
Note
•
If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
•
If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
•
If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
•
Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.
Notes
•
Use a coaxial cable to eliminate interference and
noise from radio waves.
•
Do not bundle the coaxial cable with the power
cord or other cables.
•
If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
AUDIO OUT
DIGITAL
OUTPUT
ANT /CABLE
VGA
PC / DVI
AUDIO IN
HDMI 1 / DVI
HDMI 2
(ARC)
AUDIO OUT
DIGITAL
OUTPUT
VGA
PC / DVI
AUDIO IN
HDMI 1 / DVI
HDMI 2
(ARC)
Back of TV
Coaxial cable
Note
You can also press
HDMI
repeatedly to select the
DVD or Blu-ray player.
Back of TV
DVD or Blu-ray player