6.3. AUXILIARY MODES
To perform the test mode follow the next steps:
1.
Do a short press on the “
I
” button. The start of the test mode will be indicated by a white
flashing light.
2. A test sequence is executed for each solenoid valve. If the target’s position is the memorized
position is checked for each solenoid valve. If the target’s position is correct, the control head
will be illuminated by the corresponding configured colour for each solenoid valve.
3. The control head’s light is closed during the change of the solenoid valve.
4.
To indicate the end of the test mode the control head will be illuminated by a white flashing
light for 2 seconds.
6.2. MANUALTUNE
To perform the manualtune configuration follow the next steps:
1.
Do a long press on the “
II
” button. The end of the long press will be indicated by a light green
flashing illumination and the start of the configuration by a white flashing light for 2 seconds.
2. Perform the following steps for each possible valve’s position that have to be memorized:
-place the valve on the position to be memorized. To do this you can use the manual locking
of the solenoid valves.
-
the control head will be illuminated by the corresponding configured colour.
-
do a long press on the “
II
” button to memorize the position or press “
I
” to discard it.
• If the position is memorized, the control head will be illuminated continuously light
by the corresponding configured colour for 5 seconds. Once the position is saved the
control head will be illuminated by a flashing light of the colour of the next position which
has to memorize.
•
If the position is discarded the control head illuminates by a flashing light of the colour
of the next position which has to memorize.
The maximum time to memorize the valve’s position or discard it is 120 seconds. After this
time, the configuration process will be cancelled.
-
to indicate the end of the manualtune configuration the control head will be illuminated by
a white continuous light for 5 seconds.
The manualtune programming allows the manual configuration of the control head. This mode is
used in cases where the autotune mode is not possible. For example, it is recommended in case
of double effect actuators or if you want to activate, simultaneously, more than one solenoid valve.
In this configuration mode, the positions associated with each output must be memorized one by
one.
Do a short press on the “
I
” button to cancel the process of the manualtune configuration.
Consult chapter
7. Operating problems
if an error occurs during the manualtune configuration.
The control head has two additional modes which can be useful to do check and maintenance tasks:
-test
-maintenance
6.3.1. Test mode
The test mode allows checking the control head’s configuration. Only if you create a configuration
previously, manually or automatically, you can access the test mode.
During the performance of the test mode, you can pass from checking one solenoid valve to another
by doing a short or long press on the “
I
” button.
Do a short or long press on the “
II
” button to cancel the test mode.
Puesta en marcha
15
INOXPA S.A.U.
10.426.30.03EN · (0) 2022/01
