6. Setup
The control head leaves the factory without configuration. Perform a previous setting that consists of
memorizing different positions of the shaft of the valve actuator is needed to be able to use it. Once
it is installed and is switched on for the first time, the C-TOP S flashes with a white and pink light to
indicate that it has not any position memorized.
The control head C-TOP S has two setting modes:
- autotune
- manualtune
The different setting modes of the control head are performed through the of pulsations the “
I
” and
“
II
” buttons which are in the top part of the electronic module of the control head, so to configure it
will be necessary to lift its cover.
The “
I
” y “
II
” buttons of the electronic module answer to three types of pulsations according to the
following table:
Pulsation
short pulsation
long pulsation
Time (s)
< 1
1 - 3
> 3
Signalling
light green continuous light
light green flashing light
6.1. AUTOTUNE
The autotune configuration allows an automatic configuration and it works well for most applications.
This configuration mode is recommended whenever possible.
With this configuration, the control head activates the solenoid valves sequentially and memorize the
different positions of the valve.
The autotune configuration can be carried out in two ways:
- by external signals
- by the internal signals generated by the control head itself
In the autotune configuration by the external way, when the control head receives a signal, the
corresponding solenoid valve will be activated and memorize the new position. The control head will
be pending to receive new signals for 10 minutes maximum. When the control head receives the
external signal, the new position will activate the corresponding digital output and will light the control
head according to the configured colour for this position. The control head configuration will finish if,
during these 10 minutes, all the possible input signals have been received. Otherwise, is possible to
configure the control head by internal signals generated by the control head itself.
To perform the autotune configuration by internal signals follow the next steps:
1.
Do a long press on the “
I
” button. The end of the long press will be indicated by a light green
flashing illumination and the start of the configuration by a white flashing light for 2 seconds.
2.
The control head’s configuration will start automatically activating and memorising the different
positions of the valve. The transitions between different positions will be indicated by a pink
flashing light. When memorizing each position, the control head will be illuminated by the
configured colour for such position, it will activate the corresponding outlet and it will start the
transition to the next position.
3.
To indicate the end of the autotune configuration the control head will be illuminated by a white
continuous light for 5 seconds.
Do a short press on the “
II
” button to cancel the process of the autotune configuration.
Consult chapter
7. Operating problems
if an error occurs during the autotune configuration.
Puesta en marcha
INOXPA S.A.U.
10.426.30.03EN · (0) 2022/01
14
