Inova inovabed Sofa-WallBed, Инструкция по сборке, Страница: 10 / 37

Tech support is readily available if needed
Email: support@inovabed.com
Phone: 866.528.2804
Sofa-WallBed
| ASSEMBLY MANUAL
PLEASE NOTE: Your Bed may look different
than what is shown in the pictures and
Videos throughout this manual
1. To adjust the number of springs,you will need to temporarily “walk” the
cabinet and sofa forward until it is around two feet from the wall. Do not
move the unit by grabbing the sofa arms as it may damage it. Use the
cabinet instead.
2. Working behind the cabinet, ALWAYS adjust the springs when the Bed is
in the CLOSED POSITION to add or remove springs from the spring
mechanisms as needed. The final arrangement of springs should be
symmetrical above and below the center of the mechanism. for example,if
you start with (8) springs, the center space will be empty. If you remove a
spring, you should take it off the top, but you should also move the bottom
spring to the center space. Ideally, the left and right spring mechanism should
have the same number of springs.
3. Push the cabinet and sofa back in place against the wall and test the
raising and lowering of the bed.
HOW TO
ADJUST TENSION:
STEPS FOR ADJUSTMENT:
To adjust the tension of the Sofa-WallBed:
The factory has installed the proper number of springs
based on our estimated weight of typical mattresses.
Your mattress weight may vary from these estimates.
With the springs provided, the Bed Platform should be
very easy to raise and lower.
If it is too light, it will float up a little instead of staying
down in the bed position. In this case you will need to
remove one of the springs.
If it is too heavy,it will be too difficult to lift and you will
need to add a spring.
How It Works