Inoksan BKE2000L, Руководство пользователя

Страница: 18 / 22

18
Mount the closing switch located in the machine’s lower panel left with pre-
prepared connection cables as shown in the figure.
10.5 Controls
a) Check that the water level is 1-2 cm below the
overflow pipe.
b) Check that the washing tank water temperature
is around
55-60°C from the thermometer on the
control panel.
Check that the rinsing water temperature (boiler)
is between
85-90°C from the thermometer on the
control panel.
d) Check the auto-start of the dispensary that will
be started by the technician installing the
machine.
e) Check the operation of rinsing. When the tray
is under the rinsing jet, pressurized hot water is
sprayed on dishes and the rinsing starts.
Pressurized hot water is stopped once the tray
leaves the rinsing jet.
f) Check the limit switch of the machine. When
the tray reaches the end of the counter in the
machine outlet, motor and pump should
automatically stop.
When the tray is lifted, the machine should
restart.
g) Check the directions of motor and pumps. If
they are rotating to the wrong direction,
interchange two phases from the energy
connection terminal.
11 INSTALLATION OF THE AUTOMATIC
DISPANSARY
a) Installation of the surface-active dispensary.
Connect the surface-active dispensary to the inlet
pipe in the boiler.
Electricity connection is done through feeding
terminal:
- terminals 0V – 220V ~ power source.
- terminals 31-32 carries 220 V during rinsing
WARNING: Do not directly connect the
dispensary to terminals 25 and 24 and use a
suitable relay for connection.
b) Installation of the surface-active dispensary.
The hole under the rinsing section beside washing
tank is for detergent adding nozzle.
Electricity connection should be made through
feeding terminal.
- terminals 0V – 220V power source
- terminals 31-32 carries 220 V power while
washing pump is on
UYARI: Do not directly connect the
dispensary to terminals and use a suitable
relay for connection.
c) Automatic surface active distributor dispensary
Automatic surface active distributor dispensary
should be calibrated by the technician who
installed the machine by considering the water
hardness.
Dispensary is adjusted enough that the plates and
glasses can dry for 15-30 seconds out of the
machine without falling.
Too much surface-active distributor cause white
lines on glasses.
Foam will occur if the concentration is too high or
the water temperature is too low.
d) Automatic Detergent Dispensary
Adjust the dispensary according to the
concentration of the detergent, amount of stains
on the plate and the hardness of water.
If the detergent concentration is too low, plates
will have stains and grease on them after washing.
If the concentration is too high, detergent stains
will be left on the plates and foam may occur in
the washing tank.
WARNING: FOLLOW THE
INSTRUCTIONS BELOW IN A SUITABLE
MANNER; MANUFACTURER COMPANY
IS NOT RESPONSIBLE OF ANY DAMAGES
RESULTANT OF USERS OPENING UP THE
MACHINE OR USING UNSUITABLE
EQUIPMENT.
12 SECURITY REGULATIONS FOR A SAFE
USE