Innovatech Terminator T-2100XME, Инструкция по эксплуатации

Страница: 13 / 68

Page 13 Terminator T-2100XME Manual
Blade Assembly
Blades are available in different configurations and thickness.
An assortment of blades is included in the purchase price of
the Terminator
®
. Extra blades are available upon request from
Innovatech Products & Equipment Co., Inc.
Installing a Blade
1.) Raise the blade assembly to maximum up position,
which is five inches off the floor.
2.)
Unwrap the pre-sharpened blades and select the blade
thickness and length you need for the job.
3.)
Loosen the 7 holding bolts.
4.) Insert the sharpened blade.
5.) Tighten bolts firmly, starting from the center and working
out. Bolts should be snug but not over tightened.
Taking Up Floor Coverings
1.)
Insert blade. (As explained above)
2.) Lower blade to floor. Lift caster wheel off the floor ¼
inch. Use previous procedures to drive forward.
3.)
As the Terminator
®
is removing flooring material, it is
recommended to have another person at the side of the ma-
chine remove all debris.
Ballast
The Terminator
®
is equipped with weights in front (25 pounds
each) and rear (72 pounds each) to provide traction for tough
jobs. These weights can be removed to reduce traction for
certain jobs, and to transport the Terminator
®
by forklift or truck
or elevator. Wear gloves when handling these weights. Use
caution to not smash toes and fingers. Use OSHA approved
lifting techniques.
Tricycle Or Caster Wheelbase And Tires
The tricycle wheelbase allows better turning ability. The wheel
bearings on the front caster roller require lubrication with grease
every 30 hours of machine operation. There are three fittings,
two on the wheel and one on the housing. When running over
debris such as carpet, the carpet yarn will get caught between
the wheel and the housing. Clean out wheel and housing regu-
larly.
The rear tires are solid rubber, tubeless, and require no mainte-
nance. Over time, they may wear out and need to be replaced.
Before each job, inspect the rear tires and lug bolts. Tighten the
lug bolts as needed to 70 foot-pounds torque. It is important to
keep the lug bolts tight.
Wheel hub should be tightened from 310 to 350 ft.-lbs. Inspect
and re-torque every 100 hours of operation. Lift machine off of
floor so no weight is on wheel when re-torquing pack nut.