Innovatech Terminator T-2100XME, Инструкция по эксплуатации

Страница: 12 / 68

Page 12 Innovatech Products & Equipment Co.
Manual Disconnect And Lockout
The manual disconnect is located to the right side of the op-
erator seat. To enable operation of the Terminator
®
unlock the
manual disconnect lock and pull up. In case of emergency push
down to remove power from all electrical components. Always
push down this switch to OFF when the Terminator
®
is not in
use.
Electric Motor and Batteries
The electric motor and batteries are located under the top
cover. The electric motor provides the power to the hydraulic
pump to drive the Terminator
®
.
The electric motor requires little maintenance, inspect wire
connections and check for debris to maintain its efficiency and
prolong its operating life.
Battery life can be ensured by proper periodic maintenance.
Batteries should be charged before placing the Terminator
®
into long term storage. The stored battery should be charged
monthly when not in use to prolong battery life.
Displays and Indicators
Battery Display And Hour Meter
The battery display shows pump use time, key power time and
battery life. (When the last box starts to blink, you have about
15 minutes before battery power is exhausted.)
Hydraulic Oil Over Temperature Indicator
Normal temperatures are below 120°F. Do not allow the hydrau-
lic fluid to exceed 200°F because it may damage the hydraulic
system and in turn, damage the Terminator
®
. If the indicator
light is continually coming on, turn machine off and let it cool
for 45-60 minutes. If the light regularly turns on, call Innovatech
Service Department.
Hydraulic Filter Clog Indicator
The hydraulic oil filter is equipped with a clog indicator which
will illuminate when the hydraulic oil filter is clogged. (Note: The
indicator may also inadvertently come on in cases when the
hydraulic oil is very cold, the light will stop illuminating once the
hydraulic oils has warmed to normal operating temperature.)