2.1.1
Relay Wiring Instructions
2.2
DLG-1 Mounting and Routing
The DLG-1 gauge fits in any standard 2 1/16” (52mm) gauge pod. Mounting
of the gauge should be done in such a manner that the cables are not being
forcefully pulled and strained from the gauge itself. Route the sensor and
solenoid cables avoiding contact with the exhaust system and other vehicle
components that could damage the cable. Also avoid routing the cables near
ignition components or other sources of RF (radio frequency) and EMI
(Electromagnetic interference) noise.
2.3
LC-2 Mounting
The LC-2 controller body should be mounted inside the cabin or in
another dry, protected location away from the elements. Physically mount the
unit away from all ignition or stereo components and other potentially RF or
EMI emitting sources.
Route the sensor cable in a manner that avoids contact with the
exhaust piping and other extreme heat sources that could melt the cable.
Also avoid routing the sensor cable near ignition components or other
sources of RF (radio frequency) and EMI (Electromagnetic interference).
