Installation
2
2.1
Wiring
1
On both the
DLG-1
and
LC-2,
connect the
RED
wire to an isolated
switched 12V source in your vehicle. A switched 12V source goes ON
as soon as “key on” power is active. The circuit to which you will pull
power from should be able to support a 6 amp draw (3 amps each from
the DLG-1 and LC-2.) Make sure each connection is protected with a 5A
fuse (not supplied.)
Circuits that share power with the vehicle’s stereo, ignition system,
ECU, lighting, or fuel pump should not be used. When in doubt, create an
additional circuit using an automotive relay available at any automotive parts
supplier. See the next section for a relay installation diagram.
2
On both the
DLG-1
and
LC-2,
the
BLACK
wire should be grounded to a
solid ground source. The best possible ground source would be the
battery ground (-) post.
