12
4.1
Download and Install the Logworks 3 Software
1.
Open your web browser and go to the following URL:
http://www.innovatemotorsports.com/support.php
2.
The LogWorks 3 software download will be the very first thing on the
page under the heading Software, click the link to download the
software.
3.
Double click on the Logworks 3 installer previously downloaded from the
support section of the Innovate Motorsports web site.
4.
The installer will start, follow the prompts to install the software.
5.
Once the software has been installed, the LogWorks software, LM
Programmer, manuals, and tools can then be located by navigating
through Start->Programs->LogWorks3.
4.2
LM Programmer
LM Programmer is used to configure settings on your PSB-1.
1.
Connect the OUT port of the PSB-1 to the provided serial
programming cable. Connect the other end of the serial
programming cable to your computer. If your computer does not
have a serial port, you can purchase a USB to Serial adapter from
Innovate Motorsports (P/N 3733) or use any USB to serial adaptor
that includes drivers. Make sure that nothing is connected to the IN
port of the PSB-1
2.
Power up the PSB-1.
3.
Launch LM Programmer. The LM Programmer application can be
launched from
Start->Programs->LogWorks3->LM Programmer
from
the Windows task bar.
4.2.1
Programming Analog Output
Connect the PSB-1 to the computer and launch LM Programmer. Select the
Analog Output tab. The analog output configuration screen shows voltage
versus Lambda for the analog output. The graph display is automatically
scaled to the selected voltages values. The configuration screen allows the
user to specify a minimum and maximum lambda or A/F value to a
corresponding voltage range.
By selecting the ‘use Air-Fuel-Ratio’ button you can change the displayed
unit of measure for mixture by AFR instead of Lambda. This does not
change the programming, only the unit of measure displayed in the
configuration screen.
Click the ‘Program’ button to upload your modified A/F or lambda scaling
data into the PSB-1. Once the unit has been programmed, the ‘Program’
button will grey out.
Factory Programmed Default:
