10
to the main screen if no there have been no button presses for 15
seconds.
3.1.2
Configuration using the LM Programmer software
Refer to chapter 4, Logworks 3 & LM Programmer Software Package to gain
access to the software.
1.
Connect the OUT port of the PSB-1 to the provided serial
programming cable. Connect the other end of the serial
programming cable to your computer. If your computer does not
have a serial port, you can purchase a USB to Serial adapter from
Innovate Motorsports (P/N 3733) or use any USB to serial adaptor
that includes drivers. Make sure that nothing is connected to the IN
port of the PSB-1
2.
Power up the PSB-1.
3.
Launch
LM Programmer.
The LM Programmer application can be
launched from
Start->Programs->LogWorks3->LM Programmer
from
the Windows task bar.
Once you have completed your desired changes, press the
Program
button
on the lower right on the software application. You will know that the PSB-1
has been programmed successfully when the
Program
button grays out.
3.2
Display Settings (Gauge Abbreviations)
1. MAP Units -
Allows the gauge to display pressure in either
inHG/PSI, kPa or BAR. Default setting is inHG/PSI
2. Wideband O2 Units (WB O2 Units)
– Allows the gauge to display
O2 units in either AFR or Lambda. Default setting is AFR.
3. Enable Wideband O2 (WB O2 State) –
Allows the wideband to be
disabled or enabled. Also indicates the sensor type used (sensor
type can only be changed by connecting the PSB-1 to LM
Programmer.)
NOTE: If the wideband is disabled, the O2 sensor
should be removed from the exhaust to avoid damaging it.
Default
setting is O2 enabled.
4. Fuel Type –
Change to different fuel types when PSB-1 is setup to
display in AFR. Default setting is Gasoline.
3.3
RPM Settings (Gauge Abbreviations)
1.
Mode (RPM Mode) -
Select how many pulses per rotation (ppr)
based on your tach signal source. When setting the Mode using the
