Page 2 of 10
Edition 02/24/2016
INNOTECH
EAP QUAD-13
INNO
TECH
QUADRAT-13
INSTRUCTIONS FOR
INSTALLATION AND USE
SAFETY INSTRUCTIONS
•
INNOTECH QUADRAT-13 should only be installed by specialised/competent experts
familiar with the roof safety system and in compliance with the current state of the art.
•
You must be familiar with these instructions, as well as with the local safety regulations as
a prerequisite for installing and using the system. You must also be physically and
mentally fit and trained in the use of PPE
(Personal Protective Equipment)
.
•
Medical conditions (cardiovascular problems, intake of medicines, alcohol) can affect the
safety of the user when working in high places.
•
Adhere to the respective accident prevention regulations (e.g. working on roofs) when
installing/using the attachment device INNOTECH QUADRAT-13.
•
A plan must be available that specifies rescue procedures for all possible emergencies.
•
Before starting the work, you must ensure that no objects can fall to the ground from the
work site. The area below the work site (sidewalk, etc.) must be kept clear.
•
The fitters must ensure that the ground is suited for fixing the attachment device. If in
doubt consult a structural engineer.
•
The anchorage device on the roof is designed for stress in all directions parallel to the
installation surface or at right angles to the anchor.
•
If uncertainties arise during installation it is imperative that you contact the manufacturer.
•
The roof covering must be properly sealed in accordance with applicable guidelines.
•
Document the professional fastening of the fall arrest system to the building with photos
of each fitting situation.
•
Ensure that stainless steel does not come into any contact with swarf or steel tools, as this
may lead to corrosion.
•
All stainless steel bolts must be greased with a suitable lubricant before installation.
•
You should plan, install and use the anchorage point in such a way that no one can fall
over the edge if the personal protective equipment is used properly. (See planning
documents at www.innotech-safety.eu)
•
At the access to the roof safety system you must document the positions of the anchorage
devices by means of diagrams (e.g. view of the roof from above).
•
The minimum free space necessary between the edge and the ground is calculated as
follows:
Manufacturer's specification of the personal protective equipment used including deflection
of the cable + body 1 m safety margin.
