Page 5 of 10
Edition 02/24/2016
INNOTECH
EAP QUAD-13
INNO
TECH
QUADRAT-13
FASTENING ON THE SUBSTRATE
There are several possibilities for installing the supports on the roof substrate.
The basic prerequisites are a statically bearing substructure and use of
the original fastener. If in doubt consult a structural engineer.
The height of the anchor above the surface of the structure should not exceed 300 mm.
FASTENING POSSIBILITIES:
Strictly comply with the installation manual of the fastening sets!
a) ON CONCRETE SUBSTRATE
= Fastening set
BEF 104
minimum concrete quality C 20/25
4 x Fischer FAZ II 12/10 concrete anchor on the corner bores
(comply with the instructions provided by the dowel manufacturer!)
ATTENTION Only fasten concrete anchors in structural concrete!
(do not fasten in screed, levelling concrete, blinding concrete, etc.)
User longer fastening bolts if necessary.
= Fastening set
BEF 105
(slope compensation up to 140 mm)
b) ON CORRUGATED STEEL SHEETING BEARING
SHELL
= Fastening set BEF 307
Material cross section
Corrugated steel sheeting: 0.75 mm - 1.50 mm
ATTENTION: strictly ensure that you use original
fasteners in accordance with the installation manual
included in the fastening set!
