Page 3 of 12
Edition 02/25/2016
INNOTECH
EAP QUAD-11
INNO
TECH
QUADRAT-11
INSTRUCTIONS FOR
INSTALLATION AND USE
SAFETY INSTRUCTIONS
•
Fastening on the INNOTECH QUADRAT-11 always occurs through the eyebolt with a
carabiner and must be used with personal protective equipment in accordance with EN
361 (safety harness) and EN 363 (fall arrest system).
•
For horizontal use, only those fasteners may be used that are suited for this purpose and
have been tested for the respective edges (sharp edges, sheet with trapezoidal
corrugations, steel girder, concrete, etc.).
•
There is a hazard when combining individual elements of the specified units, since the safe
function of one of the elements can be impaired through the combination. (follow the
specific instructions provided with each element!)
•
Before use, you must visually check the complete fall arrest system for obvious defects
(e.g. loose screws, deformations, abrasion, corrosion, defective roof sealing, etc.).
If there are any doubts concerning the safe function of the restraint system, it must be
inspected by an expert (written documentation).
•
At least once a year, an expert must check the complete safety device including the
personal protective equipment used. The inspection by an expert must be documented in
the provided test log.
•
After a fall and the resulting strain, you must stop using the restraint system and have it
checked by an expert (component parts, fastening to the substrate, etc.).
•
The INNOTECH QUADRAT-11 was developed for personal safety and may not be used for
other purposes. Never attach undefined loads to the restraint system.
•
Do not use safety systems if wind speeds exceed normal parameters.
•
Do not make any changes to the enabled anchorage device.
•
If used on sloping roofs, roof avalanches (ice, snow) must be avoided by means of
suitable devices to intercept snow.
•
If you provide the restraint system to external contractors, the instructions for installation
and use must be handed over in writing.
